Table of Contents
Advertisement
6. Place the J 21420-2 (1) and J 23327-2 (3), which are
part of J 23327, and J 41236 (2) on the second
coast clutch spring (224), and compress the springs.
7. Using snap ring pliers, install the second coast clutch
spring retaining ring (225) into the groove of the fluid
pump stator shaft assembly.
8. Install a steel plate (227) then a fiber plate (228).
Repeat this sequence until all 6 plates have been
installed.
9. Install the second coast clutch backing plate (229).
Automatic Transmission:
10. Using J 45164 (2), J 21420-2 (4) and J 23327-2 (1),
which are part of J 23327, compress the second
clutch spring.
11. Using J 28585 (3), install the second coast clutch
backing plate retaining ring (230) into the groove of
the fluid pump stator shaft assembly.
Second Clutch Piston Travel Measurement
Reference: "Second Coast Clutch Assemble".
Reference: "Torque Converter Housing Installation".
Special tool
J 45166 Dial Indicator Extension Rod - 8 inch"
J 45200 Dial Indicator Set
1. Install J 45166 into the fluid pump assembly bolt hole
(1) indicated with the arrow.
5A-305
Advertisement
Table of Contents
Troubleshooting
