6. Remove the A/T control wiring harness connector
retainer (69).
7. Remove the transmission wiring harness assembly
(33) from the transmission case assembly through
the wiring harness bore.
8. Remove the TCM seal (72) and the automatic
transmission wiring connector seal (46) from the
connector.
Automatic Transmission:
Installation Procedure
1. Apply GM T-IV automatic transaxle fluid GM P/N
88900925 to a NEW transaxle wiring connector O-
ring seal (46).
2. Install the NEW automatic transmission wiring
connector seal (46) in the bore for the connector.
The taper side of the seal goes up.
3. Install a NEW TCM seal (72) on the connector.
4. Install the transmission wiring harness assembly
(33) into the transmission case assembly through
the wiring harness bore.
5. Align the tab of the connector in the transmission
case.
6. Install the wiring harness connector retainer (69).
5A-221