Suzuki XL7 2007 Service Manual page 1673

3. Install the output gear retaining ring (48) into the
output gear assembly (12) groove.
Reference: "Rotational Torque Measurement".
Reference: "Low and Reverse Clutch Piston Installation".
Low and Reverse Clutch Piston Installation
1. Rotate the transmission case so the transmission
case cover side is facing up.
2. Apply automatic transmission fluid to the new seals.
3. Install the new inner (510) and outer (512) piston
seals onto the low and reverse clutch piston (511).
4. Apply automatic transmission fluid to the seal
surfaces of the transmission case.
5. By hand, press the low and reverse clutch piston
(511) into the transmission case until seated. Do not
damage the seals.
Automatic Transmission:
6. Install the low and reverse clutch spring assembly
(513) onto the low and reverse clutch piston (511),
indexing the springs to the piston bosses.
NOTE
• Do not damage the inner surface of the
transmission case assembly.
• Position the low and reverse clutch spring
retaining ring (514) opening correctly as
shown.
7. While compressing the low and reverse clutch spring
(513) by hand, install the low and reverse clutch
spring retaining ring (514) into the groove in the
transmission case assembly, making sure the open
ends face away from any openings.
Reference: "Front Internal Gear and Low and Reverse
Clutch Installation".
5A-263