Suzuki XL7 2007 Service Manual page 1632

5A-222 Automatic Transmission:
7. Apply GM T-IV automatic transaxle fluid GM P/N
88900925 to a new transaxle fluid temperature
sensor O-ring seal (32).
8. Install a new transaxle fluid temperature sensor O-
ring seal (32) into the groove of the transaxle fluid
temperature sensor (36).
9. Install the transaxle fluid temperature sensor (36)
into the front control valve body fluid temperature
sensor bore.
10. Install the transaxle fluid temperature sensor clip
(49).
11. Install the fluid temperature sensor bolt (31).
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
12. Connect the 8 solenoid wire connectors as follows:
– 1 blue
– 2 black
– 3 green
– 4 black
– 5 blue
– 6 gray
– 7 brown
– 8 black
13. Install the control valve body cover. Refer to "Control
Valve Body Cover Replacement".
14. Perform the transmission adaptive learn procedure.
Refer to "Transmission Adaptive Learn and
Transmission Neutral Learn".
Control Valve Body Replacement
Removal Procedure
NOTE
Place the transaxle in neutral (N).
1. Remove the transmission wiring harness. Refer to
"Automatic Transmission Wiring Harness
Replacement: ".
2. Remove the 2 control valve body bolts/screws (31),
control valve body fluid passage cover (37) and
gasket (38).