Suzuki XL7 2007 Service Manual page 1745

11. Connect the 8 solenoid wire connectors as follows:
– 1 - blue
– 2 - black
– 3 - green
– 4 - black
– 5 - blue
– 6 - gray
– 7 - brown
– 8 - black
12. Position the wiring harness in the wiring harness clip.
Reference: "Control Valve Body Cover Installation".
Control Valve Body Cover Installation
1. Clean any gasket material from the control valve
body cover and inspect the gasket mounting surface.
2. Apply a 3 mm (1/8 in) bead of sealant GM P/N
89020326 (Canadian P/N 89021188), to the cover
mounting surface.
Automatic Transmission:
3. Install the control valve body cover (29) onto the
transmission case assembly.
4. Apply threadlocker GM P/N 12345382 (Canadian P/
N 10953489), to the threads of all of the cover bolts.
5. Install the 9 - M8 x 1.25 x 15.5 mm control valve
body cover bolts (28).
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
6. Tighten the 9 control valve body cover bolts in
sequence.
Tightening torque
Tighten the control valve body cover bolts to 13
N⋅m (10 lb ft).
Reference: "Transmission Control Module Installation".
5A-335