Suzuki XL7 2007 Service Manual page 1660

5A-250 Automatic Transmission:
7. Remove the front internal gear (526). The front
internal gear thrust bearing assembly (519) and the
thrust washer race (530) are on the back side of the
front internal gear (526).
Reference: "Front Internal Gear and Overrun Clutch
Disassemble".
Low and Reverse Clutch Piston Removal
Reference: "Front Internal Gear and Low and Reverse
Clutch Assembly Removal".
1. Remove the low and reverse clutch spring retaining
ring (514) from the transmission case assembly.
2. Remove the low and reverse clutch spring assembly
(513).
WARNING
!
Wear safety glasses when using compressed
air in order to prevent eye injury.
3. While rotating the low and reverse clutch piston (511)
by hand, apply compressed air into the oil passage
located in the side of the transmission case and
remove the low and reverse clutch piston assembly.
4. Remove the inner seal (510) and the outer seal
(512) from the piston.
Output Gear Assembly Removal
Reference: "Low and Reverse Clutch Piston Removal".
1. Rotate the transmission assembly so the I.D. tag is
facing up.
2. Remove the output gear retaining ring (48) from the
output gear assembly (12).