Installation Procedure
1. Install the transaxle shift control bracket.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the transaxle shift control bracket.
Tightening torque
Tighten the bolts to 25 N⋅m (18 lb ft).
3. Install the shift control cable (2) to the shift control
cable bracket (3). Ensure the shift control cable
retaining tabs fully engage the shift control cable
bracket.
4. Connect the shift control cable (1) to the transaxle
range switch lever (4).
5. Install the battery tray. Refer to "Battery Tray
Replacement: ".
Automatic Transmission:
Automatic Transmission Range Selector
Lever Replacement
Special tool
J 36346 Fascia Retainer Remover
Removal Procedure
1. Remove the battery tray. Refer to "Battery Tray
Replacement: ".
2. Ensure that the shift control range select lever is in
the park (P) position.
3. Using the J 36346, disconnect the shift control cable
(1) from the transaxle range switch lever (4).
4. Depress the shift control cable retainer clip tabs (2)
and remove the shift control cable from the shift
control cable bracket (3).
5. Remove the transaxle range selector lever nut and
lever.
5A-207