Table of Contents
Advertisement
Forward and Direct Clutch End Play
Measurement
Reference: "Transmission Case Cover and 1-2 Reverse
Clutch Assembly Installation".
Special tool
J 45200 Dial Indicator Set
1. Install the transmission case cover assembly (19) to
the transmission case assembly (17).
2. Rotate the transmission case so that the front
section of the case is facing up.
3. Install J 45200 as shown and set the dial indicator to
zero.
NOTE
Excessive upward pressure will cause an
incorrect reading.
4. With one hand, carefully pull straight up on the
forward and direct clutch assembly (23) input shaft
until the assembly first bottoms out.
5. Record the measurement.
Automatic Transmission:
6. Compare the measurement with the listed
specification.
Specification
Forward and direct clutch assembly end play:
0.188 - 0.570 mm (0.007 - 0.022 in)
7. If out of specification, remove the transmission case
cover assembly.
8. Replace the forward clutch housing selective thrust
bearing race (628) as needed to obtain the correct
end play specification.
9. If the end play measurement is within specifications,
rotate the transmission case assembly so that the
transmission case cover side is facing up.
10. Remove the transmission case cover assembly (19)
and clean the sealing surfaces of the transmission
case cover (19) and the transmission case assembly
(17).
Reference: "Forward and Direct Clutch Assembly
Installation".
5A-283
Advertisement
Table of Contents
Troubleshooting
