Suzuki XL7 2007 Service Manual page 1697

1-2-Reverse Carrier Gear Assembly
Installation
1. Rotate the transmission case assembly so that the
torque converter housing side is facing up.
2. Install the 1-2 reverse internal gear rear thrust
bearing assembly (595) with the flat side up.
3. Install the 1-2 reverse internal gear shim (596)
without any markings. Correct shim selection is
performed during the front differential transfer drive
gear assembly installation.
4. Install the 1-2 reverse internal gear (594).
5. Install the 1-2 reverse internal gear front thrust
bearing assembly (593) with the flange up.
6. Install a 1-2 reverse carrier thrust washer (590) to
the lower side of the 1-2 reverse carrier gear
assembly (591).
7. Install the 1-2 reverse carrier gear assembly (591)
into the 1-2 reverse internal gear (594). The carrier
assembly will be flush to the 1-2 reverse internal
gear.
Automatic Transmission:
8. Install the other 1-2 reverse carrier thrust washer
(590) on top of the 1-2 reverse carrier gear assembly
(591).
Reference: "Third Gear Band Assembly Installation".
Third Gear Band Assembly Installation
Special tool
DT-47599 Anchor Bolt Socket
1. Install the third gear band assembly (16) into the
transmission case assembly making sure that the
band tangs are located at the servo pin.
2. Remove the bolt (1) from the holding fixture and
loosen bolt (2), to allow access.
5A-287