Table of Contents
Advertisement
Wiring Harness Removal
Reference: "Control Valve Body Cover Removal".
NOTE
Do not damage the wiring harness
connectors.
1. Disconnect the wiring harness connectors 1-8.
2. Remove the fluid temperature sensor bolt (31).
3. Remove the fluid temperature sensor clamp (49).
4. Remove the fluid temperature sensor (36) and the
O-ring (32) from the control valve body assembly.
Automatic Transmission:
5. Remove the A/T control wiring harness connector
retainer (69).
NOTE
Do not break the wiring harness connectors
or the fluid temperature sensor.
6. Remove the transmission wiring harness assembly
(33) from the transmission case assembly through
the wiring harness bore.
7. Remove the TCM seal (72) and the automatic
transmission wiring connector seal (46) from the
connector.
5A-235
Advertisement
Table of Contents
Troubleshooting
