Table of Contents
Advertisement
5A-304 Automatic Transmission:
NOTE
Make sure you have the correct number of
clutch plates, and that they are in the correct
order.
9. Install the 4 steel plates (218) and the 4 fiber plates
(217).
10. Install the second clutch backing plate (219).
11. Using J 28585 install the second clutch backing plate
retaining ring (220). Make sure that the end gap of
the retaining ring is not aligned with any of the
cutouts.
Reference: "Second Coast Clutch Assemble".
Second Coast Clutch Assemble
Reference: "Second Clutch Assemble".
Reference: "Second Clutch Piston Travel Measurement".
Special tool
J 28585 Snap Ring Remover
J 23327 Clutch Spring Compressor
J 41236 Coast Clutch Spring Compressor
J 45164 Spring Compressor Bridge
1. Apply automatic transmission fluid to the new
second coast clutch piston seals.
2. Install the new inner seal (221) and the outer seal
(223) onto the second coast clutch piston (222).
3. Apply automatic transmission fluid to the inner
surfaces of the fluid pump stator shaft assembly.
4. Press the second coast clutch piston (222) into the
fluid pump stator shaft assembly.
5. Install the second coast clutch spring assembly (224)
making sure to index the springs into the notches in
the second coast clutch piston.
Advertisement
Table of Contents
Troubleshooting
