Suzuki XL7 2007 Service Manual page 1682

5A-272 Automatic Transmission:
13. Apply automatic transmission fluid to the inner
surface of the forward clutch drum.
NOTE
Do not damage the forward clutch piston
seals.
14. Press, by hand, the forward clutch piston (565) into
the forward and direct clutch housing assembly -
with input shaft.
15. Apply automatic transmission fluid to the new direct
clutch piston seals.
16. Install the direct clutch piston inner seal (561) and
the direct clutch piston outer seal (563) onto the
direct clutch piston (562).
17. Apply automatic transmission fluid to the inner
surface of the forward clutch piston.
NOTE
Do not damage the direct clutch piston seals.
18. Press, by hand, the direct clutch piston (562) into the
forward clutch piston.
19. Install the direct clutch spring assembly (560) onto
the direct clutch piston, indexing the springs into the
holes in the direct clutch piston (562).
NOTE
Do not align the end gap of the direct clutch
spring retaining ring (559) with the spring
retainer claw.
20. Install the direct clutch spring retaining ring (559).
a. Place the J 25024-A (1) in a vise with the forcing
screw on the bottom and backed out.
b. Place the J 45186 (2) over the shaft of the
forward direct clutch housing and input shaft
assembly (567).
c. Place the J 21420-2 (4) from the J 23327 on top
of the forcing screw of J 25024-A (1).
d. With the forcing screw, compress the clutch
spring to allow the installation of the retaining
ring.