Suzuki XL7 2007 Service Manual page 1665

clear the adjustable legs and no damage to the
transmission case assembly will occur when
removing the race.
5. Tighten the bolt on J 45124 (1) to remove the front
differential bearing race (90) from the transmission
case assembly.
6. Remove the front differential bearing race selective
shim (88) from the transmission case assembly.
7. Measure the front differential bearing race selective
shim (88) to determine its size. Based on the
obtained measurement, refer to "Shim Size
Specifications" in order to determine the correct size
of shim that will be needed. If the obtained rotational
torque measurement was less than the listed
specification, then a larger/thicker selective shim will
be required. If the obtained rotational torque
measurement was greater than the listed
specification, then a smaller/thinner shim will be
required.
Reference: "Front Differential Bearing Race and
Selective Shim Installation".
Automatic Transmission:
Front Differential Bearing Race and
Selective Shim Installation
Reference: "Front Differential Bearing Race and
Selective Shim Removal".
Special tool
J 8092 Driver Handle
J 45184 Differential Bearing Race Installer
1. Once the proper shim has been selected, install the
new front differential bearing race selective shim (88)
into the transmission case assembly.
2. Using J 8092 (1) and J 45184 (2), install the front
differential bearing race (90) into the transmission
case assembly.
3. After the front differential bearing race is correctly
installed into the case, repeat the rotational torque
measurement procedure to verify that the correct
shim thickness was selected.
Reference: "Output Gear Assembly Installation".
5A-255