Table of Contents
Advertisement
Installation Procedure
NOTE
If a new steering column is being installed
then transfer the position of the alignment
marks from the old component to the same
location on the new component. Failure to
transfer the alignment marks may result in an
off-center steering wheel after installation.
1. Install the steering column into position in the
vehicle.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the steering column upper support bracket
bolts (1).
Tightening torque
Tighten the bolts to 25 N⋅m (18 lb ft).
Steering Wheel and Column:
3. Install the steering column lower support bracket bolt
(1).
Tightening torque
Tighten the bolt to 25 N⋅m (18 lb ft).
4. Connect the intermediate steering shaft to the
steering column. Refer to "Intermediate Steering
Shaft Replacement".
5. Connect the electrical connectors as needed.
6. Install the driver knee bolster reinforcement. Refer to
"Driver Knee Bolster Reinforcement Replacement: ".
7. Install the inflatable restraint steering wheel module
coil. Refer to "Inflatable Restraint Steering Wheel
Module Coil Replacement: ".
6B-14
Advertisement
Table of Contents
Troubleshooting
