NOTE
Ensure that the J 45201 is fully seated into
the transaxle seal bore.
5. Insert the collet piece (2) of the J 45201 into the
cooler line seal.
6. Insert the forcing screw piece (1) of the J 45201 into
the collet (2).
7. Tighten the forcing screw (1) until snug.
8. Thread the collar piece (1) of the J 45201 onto the
collet (3) until snug.
Automatic Transmission:
9. Turn the collar clockwise in order to remove the
cooler line seal (87).
10. Discard the seal (87).
11. Clean the case bores for the cooler line seals.
Installation Procedure
1. Insert a new transaxle cooler line seal into the case
bore.
2. Remove the nub from the J 41239-1A.
5A-227