Setting Recording Zones For Each Channel (Zone Recording) - YOKOGAWA MuR10000 Manual

6.4 Setting Recording Zones for Each Channel
(Zone Recording)
Procedure
Explanation
IM 04P01B01-01E
This section explains the details of setting the recording zone for each measurement
channel.
1.
Hold down the key for 3 seconds to enter Setting mode.
MENU
2.
Press the key or SHIFT +
3. Press the key or SHIFT +
4.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5.
When the Setting complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the ESC key.
6.
Hold down the key for 3 seconds to return to Operation mode.
MENU
Set=Aux
Aux=Zone
CH=01-01
First channel Last channel
Left= 0
Right=100
01-01 Channel
ESC/? Setting complete
Zone
The recording zone can be set in the following range.
Leftmost position: 0 mm to 95 mm
Rightmost position: 5 mm to 100 mm
Set a larger value for the rightmost position than the leftmost position.
Set at least 5 mm for the zone width.
Note
If the zone is set to a value less than 40 mm, scale printout of periodic printout cannot be
executed.
key to select Aux and then press the
key to select Zone and then press the
key.
key to select values.
Set the channel range.
Set the leftmost value of the
recording zone.
Set the rightmost value of the
recording zone.
The new setting takes effect.
1
2
3
key.
key.
4
5
6
7
8
9
10
11
12
App
Index
6-5