Setting The Computing Equation - YOKOGAWA MuR10000 Manual

9.2

Setting the Computing Equation

Procedure
9-2
The computing equation cannot be entered when the computation is in progress. If you
change the computing equation or the recording span, set the alarm and the partial
expanded recording again.
1.
Hold down the
MENU
2. key or SHIFT +
Press the
3
Press the key with Formula shown on the screen.
4.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC/?
then are cancelled, and the display returns to a higher level menu.
5. When the Setting complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
6.
Hold down the
MENU
Set=Math
Math=Formula
CH=0A-0A
First channel Last channel
Mode=Off
f.=01
Span_L=
Span_R=
0A-0A Channel
Setting complete
ESC/?
Setting the Computing Equation
The CHARACTER,
Use the key or SHIFT +
Use the CHARACTER key or SHIFT + CHARACTER key to select the character type.
key or SHIFT +
Use the
key for 3 seconds to enter Setting mode.
key to select Math and then press the
key.
key to select values.
key in the middle of the operation, the settings entered up to
ESC/?
key.
key for 3 seconds to return to Operation mode.
Set the channel range.
Select On to use the computing equation.
Set the equation.
Set the left span value.
-200.00
Set the right span value.
200.00
The new setting takes effect.
, and keys are used to set the computing equation.
key to select the position for entering a character.
key to select the character.
key.
IM 04P01B01-01E