Warning Messages - YOKOGAWA MuR10000 Manual

Code Message
351 This command cannot be specified in the current mode.
352 The option is not installed.
353 This command cannot be specified in the current setting.
354 This command is not available during calculation.
390 Command error.
391 Delimiter error.
392 Parameter error.
393 No permission.
394 No such connection.
395 Use "quit" to close this connection.
396 Failed to disconnect.
397 No TCP control block.
400 Input username.
401 Input password.
402 Select username from 'admin' or 'user'.
403 Login incorrect, try again!
404 No more login at the specified level is acceptable.
420 Connection has been lost.
421
The number of simultaneous connection has been exceeded. –
422 Communication has timed-out.

Warning Messages

Code Message
600 Initialized.
612 Some items not set.
613 Less than 10% free space on the SD card.
614 Less than 25 MB free space on the SD card.
System Errors
Code Message
902 RAM failure.
910 A/D error.
921 A/D calibration value error.
922 A/D calibration is in the wrong order.
930 Memory acquisition failure.
940 The ethernet module is down.
950 A/D number error.
951 EEPROM write error.
960 Ribbon error
961 Printer error
962 Plotter error
963 Pen 1 error
964 Pen 2 error
965 Pen 3 error
966 Pen 4 error
B5 (No messages)
B6 (No messages)
IM 04P01B01-01E
10.1 A List of Error Messages
Explanation/Countermeasures
–
–
–
–
–
–
–
–
–
Attempted to disconnect its own connection.
–
The control block of the specified connection cannot be found.
–
–
If the recorder is configured not to use the user name and
password, use user names 'admin' or 'user'.
–
–
–
–
Explanation/Countermeasures
Settings and measured data have been initialized. If this
message always appears when you turn the power off and then
back on, contact your nearest YOKOGAWA dealer.
Some of the settings could not be loaded because the model,
the number of channels, options, the setup items in basic setting
mode, or the like was different.
If you change a setup item in Basic Setting mode from the
Configuration Software, load the settings of Basic Setting mode.
See "Loading the Settings of Basic Setting Mode and Setting
Mode" in "Loading Setup Data" of the μR10000/μR20000 SD
Memory Card (/EM1 Option) User's Manual (IM 04P01B01-03E).
The amount of free space on the SD memory card is low. Stop
recording to the SD memory card and replace the SD memory card.
The amount of free space on the SD memory card is low.
Replace the SD memory card.
Explanation/Countermeasures
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
Contact your nearest YOKOGAWA dealer.
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
10-3