Chapter 7 Setup Operations For Changing/Adding Functions (Basic Setting Mode); Changing The Auxiliary Alarm Function - YOKOGAWA MuR10000 Manual

Chapter 7 Setup Operations for Changing/Adding Functions (Basic Setting Mode)
7.1

Changing the Auxiliary Alarm Function

Procedure
IM 04P01B01-01E
This section explains the details of setting the alarm system items listed below.
• Diagnosis output using the alarm output relay (I01)
• Reflash alarm operation of the alarm output relay (I01 to I03)
• AND/OR operation of alarm output relays
• Energized/De-energized operation of alarm output relays when alarms occur
• Hold/Non-hold operation of alarm output relays
• Hold/Non-hold operation of alarm indications
• The interval of the rate-of-change alarm
• Alarm hysteresis
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Changing the Settings
1.
Hold down the key for 3 seconds to enter Setting mode.
MENU
2.
Hold down the and
Setting mode.
3.
Press the key with Alarm shown on the screen.
4.
Set each item and press the
Use the key or SHIFT +
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Setting complete screen appears, do either of the following:
To correct the setting, press the
If you are done, press the ESC key.
keys simultaneously for 3 seconds to enter Basic
key.
key to select values.
key.
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
7-1