YOKOGAWA MuR10000 Manual page 80

3.3 Installing/Replacing Felt Pens or Plotter Pen (Pen Model)
Replacing the Plotter Pen
3-8
When the Pen (Pen Holder) Is at a Position That Is Not Easily Accessible
If the pen (pen holder) is at a position that is not easily accessible, carry out the
procedure below to move it near the center position.
1.
Turn ON the power switch and press the
2.
Press the (
DISP
Func=Pen exchange
3.
Press the (
CH UP
The pen (pen holder) moves near the center position, and the Pen exchange =
End appears.
Note
When the pen moves, a line is drawn on the chart paper.
4.
Replace the pen.
5. Press the (
CH UP
The screen returns to the data display screen.
1.
Open the door.
If recording is in progress, press the
2.
Open the display and key panel section.
3. Hold the plotter pen cartridge and pull it out from the pen holder.
4.
Remove the cap from the new plotter pen and insert the pen firmly into the pen
holder.
FUNC
) key several times to display the Pen exchange screen.
) key.
) key.
key to stop the recording.
RCD
key.
IM 04P01B01-01E