YOKOGAWA MuR10000 Manual page 261

Appendix
Appendix 1 Periodic Printout and Printout Using the
Periodic Printout
Pen Model
Date
Time
Channel data
Computation channel
Scale
Recording color
Chart speed
IM 04P01B01-01E
TLOG Timer (/M1 Option)
This section explains the contents of the periodic printout. The periodic printout contents
vary between the pen model and dot model. The contents also vary depending on
whether the periodic printout is in instantaneous mode, report mode, or Off.
Instantaneous mode or report mode is specified using Print1 > Mode in Basic Setting
mode.
The figure below illustrates the printout contents. The font used in the figure differs from
that of the actual printout. The printout positions may also differ from those of the actual
printout.
Instantaneous Mode
Channel number Measured
or tag
value
Mar.31.2004!
15:50*
TAG-001 1.000V
2 -1.000V
3 H-2.1050UNIT03
4 d 2.000V
TAG-00A 1UNIT0A
C L 1.00
D -10.00UNIT0D
E 1.0000%
J -1.00UNIT0J
0.000
TAG-001
RED
50mm/h_
Time tick
• Date/Time
The date/time when the periodic printout was printed on the chart paper.
• Time tick
Indicates the reference pen position at the time the periodic printout was printed on
the chart paper.
• Time tick cancel mark
Prints an exclamation point (!) when the time tick is not printed correctly.
• Offset compensation mark
Prints an asterisk (*) when offset compensation is enabled.
• Channel data
Prints the channel numbers (1 to 4 or A to J) or tags, measured/computed values, and
unit.
Prints the letter "d" on channels set to delta computation.
• Alarm
Prints the alarm that is occurring. If multiple alarms are occurring, the alarm with the
highest precedence is printed.
Alarm printout precedence: (Higher) H, L, T, t, h, l, R, r (Lower)
Time tick cancel mark
Offset compensation mark
Unit
Alarm Prints the letter "d" for channels set to
delta computation.
1
2
3
4
5
6
7
8
2.000
V
9
10
11
12
App
Index
App-1