Setting The Moving Average (Dot Model) - YOKOGAWA MuR10000 Manual

6.3

Setting the Moving Average (Dot Model)

Procedure
Explanation
6-4
This section explains the details of setting the moving average function on measurement
channels on the dot model.
1.
Hold down the
MENU
2.
Press the key or SHIFT +
3.
Press the key or SHIFT +
key.
4.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Setting complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the ESC key.
6.
Hold down the
MENU
Set=Aux
Aux=Moving_AVE
CH=01-01
First channel Last channel
No.of samples=Off
01-01 Channel
ESC/? Setting complete
The Number of Samples of Moving Average
The number of samples can be set to a integer between 2 and 16. Select Off when not
using the moving average function.
<Related Topics> Enabling the moving average function: Section 7.11
key for 3 seconds to enter Setting mode.
key to select Aux and then press the
key to select Moving_AVE and then press the
key.
key to select values.
key for 3 seconds to return to Operation mode.
Set the channel range.
Set the number of samples of the
moving average. Moving average is
not performed when Off is selected.
The new setting takes effect.
key.
IM 04P01B01-01E