Setting The Message Format (/Bt1 Option) - YOKOGAWA MuR10000 Manual

6.15 Setting the Message Format (/BT1 Option)

Procedure
Explanation
6-20
In the 5 message printouts, up to 35 characters can be printed out including the date/time
and measured values.*
• Under Message format, you can specify the printout contents of date/time, message
string, measured values,* and the order of these.
• Messages including measured values* can be printed out even when Start printout or
End printout is disabled.
• For entering message strings, see section 6.8.
* Computed values can also be included on models with the /M1 option.
1.
Hold down the
MENU
2.
Press the key or SHIFT +
key.
3.
Press the key or SHIFT +
key.
4.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Setting complete screen appears, do either of the following:
To correct the setting the
If you are done, press the ESC key.
6.
Hold down the
MENU
Entering message format
Set=Batch
Batch=MSG format
Message No.=1
Process-1
String entered for the message
13:H:M L16
Remaining number of characters
that can be printed out.
Message1 format
Setting complete
ESC/?
Message No.
Select from 1 to 5.
key for 3 seconds to enter Setting mode.
key to select Batch and then press the
key to select MSG format and then press the
key.
key to select values.
key.
key for 3 seconds to return to Operation mode.
Select message number.
Set the message format.
The new setting takes effect.
IM 04P01B01-01E