YOKOGAWA MuR10000 Manual page 138

6.14 Setting Up Start Printout and End printout (/BT1 Option)
Explanation
6-18
Setting the Feed Amount, Lot Number Update, and Ejection of Pen Offset
Compensating Data
Set=Batch
Batch=Detail
Mode=Start
Detail=Action
Feed= 0
(Only when the Mode is End or End 2
and the lot number is 4 or 6 digits)
Auto inc.=On
(Only when the Mode is End or End 2
and pen model offset compensation is On)
POC output=On
(Only when POC output is On)
POC speed=C.Speed
Batch action
ESC/? Setting complete
Batch No.
You can enter up to 26 characters.
The following are the characters that can be used.
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω,
Lot No.
Enter using a 4 or 6 digit number. Select which number of digits to use (4 or 6) under
"Lot No." in Basic Setting mode.
Mode
Select Start, End, Start 2, or End 2. Start 2 and End 2 become available when you
enable "Dual comment" in Basic Setting mode.
Line No.
1 to 5 lines can be printed out.
Comment
You can enter up to 32 characters.
The following are the characters that can be used.
Alphabet, numbers, symbols (%, #, °, @, +, –, *, /, (, ), µ, Ω,
Select Detail.
Select Start, End, Start2, or End2.
Select Action.
Set the chart paper feed amount before
Start printout and after End printout.
Select whether to update (+1) lot number
when recording stops. Select On or Off.
Select whether to eject the pen offset
compensating data when recording
stops. Select On or Off.
Select the chart speed when ejecting the
pen offset compensating data.
The new setting takes effect.
2 3
, , .), and space
2 3
, , .), and space
IM 04P01B01-01E