YOKOGAWA MuR10000 Manual page 64

2.3 Input Signal Wiring
2-6
Dot Model
b +/A
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Screw input terminal
1.
Turn OFF the recorder and remove the terminal cover.
2.
Connect the signal wires to the terminals.
Signal wire
Crimp-on lug with
insulation sleeves
Philips
screwdriver
Note
Input signal wires of diameter less than or equal to 0.3 mm may not be secured firmly for
clamped terminals (/H2). Fold over the conducting section of the wire, for example, to make
sure that the wire is securely connected to the clamped terminal.
3. Replace the terminal cover and fasten it with screws.
The proper torque for tightening the screws is 0.6 N•m.
+A
Channel 2
b
Channel 4
Channel 6
Clamped input terminal
Screw input terminal
Signal wire
+/A
Channel 1
b
Channel 3
Channel 5
(/H2 option)
Clamped input terminal
Flat-blade
screwdriver
IM 04P01B01-01E