Printing Messages - YOKOGAWA MuR10000 Manual

3.10 Printing Messages

Procedure
3-16
This section explains the procedure for printing the preset character strings. For the
procedure of setting the character strings, see section 6.8.
Note
• Messages can be printed only during trend recording. However, regardless of whether trend
recording is ON or OFF, messages waiting to be printed are temporarily stored in the buffer
memory.
• Message printouts are not performed when the chart speed is greater than or equal to 1600
mm/h and 101 mm/h on the pen model and dot model, respectively.
Printing a Message
1.
Press the key.
FUNC
2.
Press the key to select Message and then press the
Func=Message
3.
Press the key to select message number and then press the
The message printout starts. The screen returns to the data display screen.
Message=Message1
Clearing the Message Printout Buffer
Messages waiting to be printed are temporarily stored in the buffer memory. This
operation clears the messages in the buffer.
1.
Press the key.
FUNC
2.
Press the key to select Buffer clear and then press the
3.
Press the key to select Message and then press the
The messages in the printout buffer are cleared. The screen returns to the data
display screen.
Buf.clear=Message
* When the key or
when the respective key is pressed by itself.
Displays the preset message.
key is pressed while holding down the SHIFT key, the operation is reversed as
key.
key.
key.
key.
IM 04P01B01-01E