Recorder's Version And Functions Described In This Manual - YOKOGAWA MuR10000 Manual

Recorder's Version and Functions Described in This
Manual
The contents of this manual corresponds to the recorder with version 1.4x.
µR10000 Versions and Functions
Version Suffix Code Added or Modified Functions
1.02 or earlier –
1.1x –
–
–
–
/C3
/C7
1.2x -2
/CC1
/H5x
/P1
1.3x –
–
/BT1
1.4x /EM1
• Checking the Version Number
You can check the version number on the System display.
The System display cannot be shown at the factory default condition.
First, register the System display to the display screen.
• Procedure of registering the System display to the display screen: See section 8.2.
• Procedure of displaying the System display: The screen switches each time the
the key repeatedly until System display is shown. The displayed contents on the System display
DISP
switches every 3 seconds. Check the number shown by the "Version:" item.
Software (Sold Separately)
The table below shows the relationship between the RXA10 Configuration Software revisions and the µR10000
recorder versions.
RXA10 Configuration
Software revision
Yes: Compatible
Limited: The new functions of the recorder cannot be configured from the RXA10.
ii
–
(Added) The printout/display format of the date can be changed. Section 7.19
(Added) Key operation to move the printer carriage near the
center position so that the ribbon cassette can be
replaced with the recorder turned ON (dot model)
(Changed) Selectable range of alarm values during linear scaling
(including 1-5V and SQRT) to –5% to 105% of the
scale span.
(Changed) The procedure to set the start/end date and time of
Daylight Saving Time (DST) has been changed.
(Added) Modbus/RTU slave protocol, two-wire system.
(Changed) Users with the same user name cannot be registered.
(Added) Language support (German and French).
(Added) Calibration Correction.
(Added) Portable type.
(Added) 24 VDC/AC power supply operation.
(Added) Customized menu.
(Added) Modbus register (40301 to 40348).
(Added) Header printout.
(Added) SD memory card.
1.02 or earlier
R1.01 Yes
R2.01 Yes
R3.01 Yes
R3.05 Yes
Note
Set the recorder version in the RXA10 Configuration Software to display the setup items that
match the recorder's functions.
Recorder version
1.1x 1.2x 1.3x
Limited
Yes Yes Limited
Yes Yes Yes
Yes Yes Yes
Reference
–
Section 3.4
Section 5.2
Section 6.16
Communication manual
Communication manual
Section 1.9
Section 1.2
Sections 2.5 and 12.7
Section 2.5
Section 1.9
Communication manual
Section 1.4
IM 04P01B01-03E
key is pressed. Press
DISP
1.4x
Limited
Yes
IM 04P01B01-01E