Setting The Timer Used In Tlog Computation And Periodic Printout - YOKOGAWA MuR10000 Manual

9.12 Setting the Timer Used in TLOG Computation
and Periodic Printout
Procedure
9-20
This section explains the details of setting the timer used in TLOG computation and
periodic printout.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Changing the Settings
1.
Hold down the
MENU
2.
Hold down the
Setting mode.
3. key or SHIFT +
Press the
4.
Press the key with Timer (TLOG) shown on the screen.
5.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
6.
When the Setting complete screen appears, do either of the following:
To correct the setting, press the
If you are done, press the ESC key.
Basic=Math
Math=Timer(TLOG)
Timer No.=1
Mode=Absolute
Interval=1h
(When the mode is set to Absolute)
Ref.Time=00:00
Reset=Off
Print=Off
Math Timer
Setting complete
ESC/?
key for 3 seconds to enter Setting mode.
and keys simultaneously for 3 seconds to enter Basic
key to select Math and then press the
key.
key to select values.
key.
Select the timer No.
Select the timer type.
Select the timer interval.
Set the reference time.
Select On to reset the computed
values every interval.
Select On to print the computed
values every interval.
The new setting takes effect.
key.
IM 04P01B01-01E