Enabling The Bias, Low-Cut, Alarm Delay, Calibration Correction (/Cc1 Option) Functions - YOKOGAWA MuR10000 Manual

7.15 Enabling the Bias, Low-Cut, Alarm Delay,
Calibration Correction (/CC1 Option) Functions
Procedure
IM 04P01B01-01E
This section explains the details of enabling/disabling the bias, low-cut, alarm delay, and
calibration correction (/CC1 option) functions.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Changing the Settings
1.
Hold down the key for 3 seconds to enter Setting mode.
MENU
2. Hold down the and
Setting mode.
3. Press the key or SHIFT +
key.
4. Press the key with Add function shown on the screen.
5.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
6.
When the Setting complete screen appears, do either of the following:
To correct the setting, press the
If you are done, press the ESC key.
Basic=Personalize
Mode=Add function
Bias=Not
SQRT low-cut=Use
1-5V low-cut=Not
Alarm delay=Not
(/CC1 option)
Calibration=Not
Personalize
ESC/? Setting complete
keys simultaneously for 3 seconds to enter Basic
key to select Personalize and then press the
key.
key to select values.
key.
Enable/Disable the bias function.
Enable/Disable the low-cut function on
channels set to square root computation.
Enable/Disable the low-cut function on
channels set to 1-5V.
Enable/Disable the alarm delay function.
Enable/Disable the calibration correction
function.
The new setting takes effect.
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
7-23