Panasonic MINAS A5 Series Operating Instructions Manual page 93

2.
Overall Wiring (H-frame, 400 V type)
: High voltage
24V 0V DB1 DB2
L1 L2 L3 B1 B2 NC
Ground
(earth)
Ground terminal
Motor cable (Shield wire)
Brake cable
DC Power supply
for brake DC24V
(to be supplied
by customer)
Note • The figure above shows connections on velocity, position, torque and full-closed mode driver.
• Only for position control type is not provided.
Related page
• P.2-46 "Wiring of the Main Circuit (H-frame, 400 V type)"
• P.2-48 "Specifications of Motor connector"
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
P.2-60
X1
X2
X3
X4
X5
X6
CHARGE
U V W
Junction cable
for encoder
U
-phase
V
-phase
-phase
P.2-46
PC (to be supplied by customer)
Setup support software
"PANATERM"
Please download
from our web site.
or host controller
feedback scale
encoder
connect these terminals to the primary power
supply (particularly, the 24 VDC power supply for
control, the 24 VDC power supply for brake, and
the 24 VDC power supply for regenerative
resistor), insulation is required.
Do not connect these terminals to the same power
supply.
resistor, connect the external regenerative resistor
between B1 and B2, set up Pr0.16 to 1 or 2.
resistor, connect the magnetic contactor (for
controlling) for external dynamic brake to between
LIC and DB1.
filter.
1
2
P.2-51
P.2-51
3
P.2-53
P.2-54
P.2-55
4
P.2-57
5
6
7
2-45