Panasonic MINAS A5 Series Operating Instructions Manual page 84

2
Preparation
Connecting Example of F-frame
from the power source.
Symmetric current should be 5000 Arms or below.
If the short-circuit current on the power source
exceeds this value, use a current-limiting device
(e.g. current-limiting fuse, current-limiting circuit
breaker or transformer).
To protect power supply line from overload-
ing, install a wiring circuit breaker rated to
the capacity of the power supply.
Removes external noise from the power
lines. And reduces an effect of the noise
generated by the servo driver.
Turns on/off the main power of the servo
driver.
Use coil surge suppression units together
with this.
(to be supplied by customer)
Reduces harmonic current of the main
power.
normal operation.
regenerative resistor, disconnect a
then connect the external regen-
Note
application. The wiring indicated with the broken line shall be provided only when required.
Related page
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
2-36
2.
Overall Wiring (F-frame, 400 V type)
current device
* Use a power
supply with
Residual
2 A or larger
capacity.
regenerative resistor (Option).
(to be supplied by customer)
24V
0V
L2