Panasonic MINAS A5 Series Operating Instructions Manual page 81

2.
Overall Wiring (D, E-frame, 400 V type)
: High voltage
Handle lever
Use this for connector
connection. Store this
after connection for
other occasions.
(Refer to P.2-50 for
connection.)
Short circuit wire (B2-B3)
U-phase(red)
V-phase(white)
Ground
terminal
Brake cable
DC Power supply for brake
DC24V
(to be supplied by customer)
*1 Do not make displacement, wiring or inspection while the LED is lit - cause of electric shock.
Note • The figure above shows connections on velocity, position, torque and full-closed mode driver.
• Only for position control type is not provided with X2, X3 and X5.
Related page
• P.2-34 "Wiring of the Main Circuit (D, E-frame, 400 V type)"
• P.2-48 "Specifications of Motor connector"
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
P.2-60
P.2-34
Charge lamp
Ground
(Red LED)
(earth)
Junction cable
for encoder
PC
(to be supplied by customer)
Setup support software
Please download
from our web site.
or host controller
circuit. To connect these terminals to
the primary power supply (particularly,
*1
the 24 VDC power supply for control
and the 24 VDC power supply for
brake), insulation is required.
Do not connect these terminals to the
same power supply.
P.2-34
P.2-51
P.2-51
P.2-53
P.2-54
P.2-55
feedback scale
P.2-57
encoder
2-33
1
2
3
4
5
6
7