Panasonic MINAS A5 Series Operating Instructions Manual page 72

2
Preparation
Connecting Example of G-frame
from the power source.
Symmetric current should be 5000 Arms or below.
If the short-circuit current on the power source
exceeds this value, use a current-limiting device
(e.g. current-limiting fuse, current-limiting circuit
breaker or transformer).
To protect power supply line from overloading,
install a wiring circuit breaker rated to the capacity
of the power supply.
Removes external noise from the power lines. And
reduces an effect of the noise generated by the
servo driver.
Turns on/off the main power of the servo driver.
Use coil surge suppression units together with this.
(to be supplied by customer)
Reduces harmonic current of the main power.
regenerative resistor (Option).
The wiring indicated with the broken line shall be
provided only when required.
Note
application. The wiring indicated with the broken line shall be provided only when required.
Related page
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
2-24
2.
Overall Wiring (G-frame, 200 V type)
(optional)
.
.
Residual
current device
P.2-26
B1
B2
resistor, connect the external regenerative resistor
between B1 and B2, set up Pr0.16 to 1 or 2.
･
･ To connect the external dynamic brake resistor,
P.2-26
L1C
L2C
L1
L2
L3