Panasonic MINAS A5 Series Operating Instructions Manual page 46

5. Installation
Motor
Wiring Precautions on Movable Section
When wiring cable bear, take the following precautions:
cable is free from any stress (e.g. tension). (Avoid tight lock.)
[Recommended cable bear wiring]
Do not keep the cable loosened (too long) or under tension (too short).
Caution
Otherwise, the sheath will be cracked by internal wall of the cable bear, tangled by other
cable, etc., causing unpredictable troubles.
Keep the cable free from twists or kinks.
Distorted cable will cause loose connection, lowering performance and reliability.
other and measure the dimension necessary to cover these cables. Then select a ca-
ble bear which is wider than the measured dimension.
The lamination factor of cables should be lower than 60% (recommended factor is 30%
or below).
Do not run smaller and larger size cables in the same cable bear. Thin cables may
break under the pressure of thick cables. If it is necessary to mix cables of different
size, isolate them by using suitable separating material such as partition.
[Wiring arrangement in cable bear – example]
1-34
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Cable
Cable
Partition
Thick cable Thin cable
Cable bear
Cable end
Cable Partition