Chrysler 2005 Crossfire SRT6 Service Manual page 89

ZH
7. Remove the snap ring (4) from the rear hub
assembly housing.
8. Using the Special Tool 9181 Bearing Tool, remove
the bearing (4) on the hub (1).
CAUTION: Be sure not to mar or damage the rear
axle halfshaft flange while in vise.
9. Remove the inner bearing race from the rear axle
halfshaft flange by screwing the clamping pliers
onto the puller then tighten.
10. Clamp the rear axle halfshaft flange in vise.
11. Fit the thrust piece with the large diameter on the
rear axle halfshaft flange.
12. Place the complete puller over the inner bearing
race.
13. Clamp it firmly at the upper grooves of the clamp-
ing pliers over the tapered sleeve of the puller.
14. Pull the inner bearing race off the rear axle half-
shaft flange using the puller.
15. Check the lateral and radial runout of the rear axle halfshaft flange. Replace rear axle halfshaft flange if test
values are exceeded.
• Permissible lateral runout 0.0011 in. (0.03 mm).
• Permissible radial runout 0.0011 in. (0.03 mm).
REAR SUSPENSION 2 - 65