Chrysler 2005 Crossfire SRT6 Service Manual page 43

ZH
Note: An allen wrench may be required to hold the
ball joint stud while removing the nut.
11. Remove the steering knuckle upper control arm
nut (1) from the upper ball joint stud.
CAUTION: Do not use pneumatic tools to tighten
the bolt on the special tool.
12. Using Special Tool 9168 Ball Joint Puller slowly
tighten the bolt until the upper ball joint is pushed
out of the steering knuckle.
13. Carefully remove the knuckle from the vehicle.
INSPECTION
1. Check the lower control arm supporting ball joint by
performing the following:
2. Remove the nuts (1) from the lower control arm
supporting ball joint.
3. Using Special Tool 9168 Ball Joint Puller (2) press
out the lower control arm supporting ball joint (1).
4. Check the lower control arm supporting ball joint. It
should be possible to move the ball pivot without
any play, binding, or creaking noises. Move the ball
pivot in all directions with a tube approximately 6
in. (150 mm) in length. Check the boot for any
cracks or damage. If the boot is leaking, replace
supporting or follower joint.
5. Measure the steering knuckle, if necessary.
FRONT SUSPENSION 2 - 19