Chrysler 2005 Crossfire SRT6 Service Manual page 123

ZH
2. Remove the inner C/V boot retaining clamp (1)
from the axle halfshaft.
3. Remove the outer C/V boot retaining clamp (2)
from the C/V joint housing.
4. Clamp the axle halfshaft in a vise.
CAUTION: Insure to use a vise that is equipped
with protective caps on the jaws of the vise to pre-
vent any damage to the axle halfshaft.
5. Remove the C/V boot from the inner C/V joint
housing and slide it down the axle halfshaft.
6. Wipe away the grease to expose the inner C/V
joint and the halfshaft.
7. Using a soft–faced hammer sharply hit the end of
the C/V joint housing to dislodge the housing from
the internal circlip on the axle halfshaft.
8. Slide the inner C/V joint off the end of the halfshaft.
HALFSHAFTS 3 - 7