Chrysler 2005 Crossfire SRT6 Service Manual page 131

ZH
5. Align the splines on the axle halfshaft (1) with the
splines on the C/V joint assembly (3).
6. Install the outer C/V joint assembly onto the axle
halfshaft by using a soft–faced hammer and tap-
ping the end of the stub axle (with nut installed)
until the outer C/V joint is fully seated on the axle
halfshaft.
Note: The C/V joint assembly must be installed on
axle halfshaft until the C/V joint assembly is
seated against the circlip on the halfshaft.
Note: Do not use any other type of grease other
than what is supplied in the C/V boot service
package.
7. Pack approximately 1/2 the amount of grease pro-
vided in the C/V boot service package into the
outer C/V joint cavity.
8. Pack the remaining amount of grease into the C/V
boot.
HALFSHAFTS 3 - 15