Chrysler 2005 Crossfire SRT6 Service Manual page 135

ZH
4. Clamp the axle halfshaft in a vise.
CAUTION: Insure to use a vise that is equipped
with protective caps on the jaws of the vise to pre-
vent any damage to the axle halfshaft.
5. Remove the C/V boot from the C/V joint housing
and slide it down the axle halfshaft.
6. Wipe away the grease to expose the C/V joint and
the halfshaft.
7. Using a soft–faced hammer sharply hit the end of
the C/V joint housing to dislodge the housing from
the internal circlip on the axle halfshaft.
8. Slide the C/V joint off the end of the halfshaft.
9. Thoroughly clean and inspect the C/V joint assem-
bly for any signs of excessive wear. (Refer to 3 -
DIFFERENTIAL & DRIVELINE/HALF SHAFT/CV
JOINT - INSPECTION).
HALFSHAFTS 3 - 19