Chrysler 2005 Crossfire SRT6 Service Manual page 126

3 - 10 HALFSHAFTS
Note: The C/V boot must be positioned on the axle
halfshaft so the raised bead on the inside of the
C/V boot is in the groove on the axle halfshaft.
9. Install the C/V boot outer end into the sealing
groove (1) of the C/V joint housing.
10. Install the C/V boot inner end into the sealing
groove of the axle halfshaft.
11. Position the inner C/V boot retaining clamp (1)
and the outer C/V boot retaining clamp (2) into the
sealing grooves on the C/V boot.
12. Position the crimping tool (1) on the C/V boot
retaining clamp (3).
ZH