Disassembling The Tilt Cylinder; Checking The Tilt Cylinder And Piston - SELVA MARINE Wahoo 15 Service Manual

BRKT

Disassembling the tilt cylinder

1. Hold the tilt cylinder 1 in a vise using
aluminum plates a on both sides.
2. Loosen the tilt cylinder end screw, and
then remove the tilt ram assembly.
1
a
WARNING
Make sure that the ram is fully extended
before removing the end screw.
Power tilt wrench 2: 90890-06560
3. Drain the power tilt fluid.
4. Remove the cylinder liner 3 and free
piston 4 from the cylinder 1.
4
3
7-43
Bracket unit
2
a
S6AG7215
1
S6AG7250
5. Remove the bolt 5, and then remove the
7
piston absorber valves 6 from the tilt
piston.
T30
6. Hold the tilt piston 7 in a vise using alu-
minum plates on both sides, and then
remove the tilt piston 7 and tilt cylinder
end screw 8 from the tilt ram assembly
9.
Power tilt wrench 2: 90890-06560

Checking the tilt cylinder and piston

1. Check the cylinder liner 1. Replace if
cracked or scratched.
2. Check the tilt piston 2, free piston 3,
and backup rings 4 and 5. Replace if
cracked or scratched.
5
9
2
8
7
6
S6AG7260
S6AG7235
7
6AG3J11