indicator
RJ-45 port indicator
Status
Link
indicator
Transmission
Act
Indicator
1.4.2.2.3
Front Panel Port Description
The EM4700BD-12GT-RJ45 provides 12 RJ45 copper Gb ports.
Port Type
RJ-45 port
1.4.2.2.4
Front Panel – Reset Button
The EM4700BD-12GT-RJ45 provides a RESET button for resetting the board.
1.4.2.2.5
Front Panel – SWAP Button
The EM4700BD-12GT-RJ45 provides a SWAP button for hot swapping the module during
operation. Before removing the module, users should press the SWAP button first. The module will
then prepare for a hot-swap and the system operation indicator (RUN) will turn yellow and blink at
8 Hz. When the RUN indicator is off, the card is powered off and can be removed.
1.4.2.3 EM4700BD-12GX-SFP
12 fiber Gb ports line card (EM4700BD-12GX-SFP): supports 12 SFP Gb fiber ports for layer 2 and
layer 3 switching and routing.
1.4.2.3.1
Front Panel
EM4700BD-12GX-SFP provides 12 SFP ports.
The Front Panel view is shown below:
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
On (Green, blinks at 8 Hz)
On (Yellow, blinks at 8 Hz)
On (Red, blinks at 8 Hz)
Off
On (Green)
Off
Blinking (Green)
Table 1.5 EM4700BD-12GT-RJ45 port description
10/100/1000 Mbps auto sensing
MDI/MDI-X cable ant sensing
Cat 5 UTP: 100 m
System is loading (Booting after card
hot swapping)
System is shutting down (Shutting
Down after SWAP button pressed)
Malfunction status
Card is powered off and can be
removed
Network connection on SFP transceiver
is normal
No network connection present on SFP
transceiver
Sending or receiving data
Specification
42