Debug Devsm; Card Hot-Swap Operation; Card Hot-Insertion; Card Hot-Remove - Accton Technology ES4710BD User Manual

Example:
Switch # show power
----------power information----------
power1 Inserted: NO
power2 Inserted: NO
power3 Inserted: YES

6.2.2.1.4 debug devsm

Command: debug devsm { send | receive | state }
no debug devsm {send | receive | state }
Function: Displays the device management packet traffic and cards status conditions. The "no
debug devsm {send | receive | state }" command disables DEBUG display.
Parameters: send displays outgoing device management packets.
receive displays incoming device management packets.
state displays card status change information
Default: Debugging information is disabled by default.
Command mode: Admin Mode

6.3 Card Hot-Swap Operation

ES4710BD supports hot swapping of cards. Hot swapping of non-master control boards/cards
will not affect the normal operation of other line cards.

6.3.1 Card Hot-Insertion

The cards are automatically powered once inserted into the slots. A blinking RUN indicator in
1Hz indicates the card is working normally. User entry recognition by the switch will be stopped
during the hot insertion of cards and resumed once the cards enter normal operation mode.

6.3.2 Card Hot-Remove

EES4710BD 10 Slots L2/L3/L4 Chassis Switch
153