Table of Contents
Advertisement
18.5.3.1.4 Configure OSPF area for port
Click "OSPF area configuration" to enter the configuration page for port. Equivalent to CLI
command 18.4.2.2.9
Vlan port: port list
Area ID: area number
Reset: resets each column value to default in this page and this action will not change settings
Apply: valid each column value. This action will change settings.
Default: resets to default setting. This action will change settings.
Example: to configure port vlan 1 to area 1, port select vlan 1, key-in area number 1 and click Apply
button.
18.5.3.2 OSPF TX-parameter configuration
Click "OSPF Tx-parameter configuration" to open the configuration table. Includes:
OSPF authentication parameter configuration
Passive interface configuration: Configures OSPF port as receiving packets only
Sending packet cost configuration: configures the cost and timer parameter for the port
sending data packets.
18.5.3.2.1 Configure OSPF authentication parameter configuration
Click "OSPF authentication parameter configuration" to enter the configuration page. Equivalent to
CLI command 18.4.2.2.6
Vlan port: port list
Authentication mode: simple and MD5.
Authentication key
KeyID: the authentication word in MD5 authentication mode
Reset: resets each column value to default in this page and this action will not change settings
Apply: valid each column value and this action will change settings
Example: To configure MD5 authentication mode in port vlan 1, authentication key as 123abc and
the key ID as 1: select vlan1, MD5 and key-in authentication key as 123abc and key ID as 1.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
451
Advertisement
Table of Contents
Troubleshooting
