Table of Contents
Advertisement
QoS status－Close or Open.
To enable QoS, select Open, then click Apply.
16.5.2 Class-map configuration
Click "Class-map configuration" to display the extension, including the following two sections:
1.
Add/Remove class-map
2.
Class-map configuration
16.5.2.1 Add/Remove class-Map
Click "Add/Remove class-map" to enter configuration page. Equivalent to CLI command 16.2.2.2.
Term description as follows:
Class-map name
Operation type－Create class table and Remove class table.
Example: Enter a class-map name, select Create class table, then click Apply.
16.5.2.2 Class-map configuration
Click "Class-map configuration" to enter the configuration page. Equivalent to CLI command
16.2.2.3.
Terms are described as following:
Class-map name
Match action which including:
access-group First valid－mapping to ACL table. Parameter is the assign number or
name of ACL. First valid means Match value 1 is valid.
ip dscp－mapping to DSCP. Parameter is the DSCP value list.
ip precedence－mapping to IP priority. Parameter is IP priority value list.
vlan－mapping to VLAN ID. Parameter is VLAN ID value list.
Match value 1-8－mapping to parameter value table. Input ACL value to match value 1
for mapping ACL.
Operation type－Sets or Removes.
To configure Class-map c1, select c1 to Class-map name, select ip dscp to Match action, input 3 to
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
357
Advertisement
Table of Contents
Troubleshooting
