Table of Contents
Advertisement
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
7.2.3.2.2 interface ethernet
Command: interface ethernet <interface-name>
Function: Enters network management port configuration mode from Global Mode.
Parameters: <interface-name> stands for port number, the default value is 0.
Command mode: Global Mode
Usage Guide: Run the exit command to exit the network management Interface Mode to Global
Mode.
Example: Entering network management interface mode.
Switch(Config)#interface ethernet 0
Switch(Config-Ethernet0)#
7.2.3.2.3 ip address
Command: ip address <ip-address> <mask>
no ip address [<ip-address> <mask>]
Function: Sets the IP address and mask for the switch; the "no ip address [<ip-address> <mask>]"
command deletes the specified IP address setting.
Parameters: <ip-address> is the IP address in decimal format; <mask> is the subnet mask in
decimal format.
Command mode: Network management port configuration Mode
Default: No IP address is configured by default.
Usage Guide: This command configures the IP address for network management port.
Example: Setting the IP address of the network management interface to 192.168.1.10/24.
Switch(Config-Ethernet0)#ip address 192.168.1.10 255.255.255.0
7.2.3.2.4 loopback
Command: loopback
no loopback
Function: Enables the loopback test function for the network management port; the "no loopback"
command disables the loopback test the on network management port.
Command mode: Network management port configuration Mode
Default: Loopback test is disabled in network management port by default.
Usage Guide: Loopback test can be used to verify the network management port is working
normally. After loopback has been enabled, the port will assume a connection established to itself,
and all traffic sent from the port will be received at this very port.
Example: Enabling loopback test in the network management port.
Switch(Config)#interface ethernet 0
Switch(Config-Ethernet0)#loopback
169
Advertisement
Table of Contents
Troubleshooting
