Table of Contents
Advertisement
Scenario 1: The switch is used as FTP/TFTP client. The switch connects from one of its ports to a
computer, which is a FTP/TFTP server with an IP address of 10.1.1.1; the switch acts as a
FTP/TFTP client, the IP address of the switch management VLAN is 10.1.1.2. Download "nos.img"
file in the computer to the switch.
FTP Configuration
Computer side configuration:
Start the FTP server software on the computer and set the username as "Switch", and the password
as "edgecore". Place the "12_30_nos.img" file in the appropriate FTP server directory on the
computer.
The configuration procedures of the switch are listed below:
Switch(Config)#inter vlan 1
Switch (Config-If-Vlan1)#ip address 10.1.1.2 255.255.255.0
Switch (Config-If-Vlan1)#no shut
Switch (Config-If-Vlan1)#exit
Switch (Config)#exit
Switch#copy ftp://Switch:edgecore@10.1.1.1/12_30_nos.img nos.img
With the above commands, the switch will have the "nos.img" file in the computer downloaded to
the FLASH.
TFTP Configuration
Computer side configuration:
Start TFTP server software on the computer and place the "nos.img" file to the appropriate TFTP
server directory on the computer.
The configuration procedures of the switch is listed below:
Switch (Config)#inter vlan 1
Switch (Config-If-Vlan1)#ip address 10.1.1.2 255.255.255.0
Switch (Config-If-Vlan1)#no shut
Switch (Config-If-Vlan1)#exit
Switch (Config)#exit
Switch#copy tftp://10.1.1.1/12_30_nos.img nos.img
Scenario 2: The switch is used as a FTP server. The switch operates as the FTP server and connects
from one of its ports to a computer, which is a FTP client. Transfer the "nos.img" file in the switch
to the computer and save as 12_25_nos.img.
The configuration procedures of the switch are listed below:
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
133
Advertisement
Table of Contents
Troubleshooting
