Accton Technology ES4710BD User Manual page 410

d. Configure OSPF packet sending timer parameter (timer of broadcast interface sending
HELLO packet to poll, timer of neighboring layer 3 switch invalid timeout, timer of LSA
transmission delay and timer of LSA retransmission.
Command
Interface Mode
ip ospf hello-interval <time>
no ip ospf hello-interval
ip ospf dead-interval <time >
no ip ospf dead-interval
ip ospf transmit-delay <time>
no ip ospf transmit-delay
ip ospf retransmit <time>
no ip ospf retransmit
(2) Configure OSPF route introduction parameters
a. Configure default parameters (default type, default tag value, default cost, default interval
and default number uplimit)
Command
OSPF protocol configuration mode
default redistribute type { 1 | 2 }
no default redistribute type
default redistribute tag <tag>
no default redistribute tag
default redistribute cost <cost>
no default redistribute cost
default redistribute interval <time>
no default redistribute interval
default redistribute limit <routes>
no default redistribute limit
b. Configure the routes of the other protocols to introduce to OSPF.
Command
OSPF protocol configuration mode
redistribute ospfase { bgp | connected |
static | rip} [ type { 1 | 2 } ] [ tag <tag> ]
[ metric <cost_value> ]
no redistribute ospfase { bgp | connected |
static | rip }
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Explanation
Sets interval for sending HELLO packets; the "no
ip ospf hello-interval" command restores the
default setting.
Sets the interval before regarding a neighbor layer
3 switch invalid; the "no ip ospf dead-interval"
command restores the default setting.
Sets the delay time before sending link-state
broadcast; the "no ip ospf transmit-delay"
command restores the default setting.
Sets the interval for retransmission of link-state
advertisement among neighbor layer 3 switches;
the "no ip ospf retransmit" command restores the
default setting.
Explanation
Sets the default route weight for route to be
introduced; the "no default-metric" command
restores the default setting.
Sets the default tag value for introducing external
routes; the "no default redistribute tag"
command cancels the tag value setting.
Sets the default cost for introducing external
routes; the "no default redistribute cost"
command cancels the cost for introducing external
routes. .
Sets the interval for introducing external routes;
the "no default redistribute interval" command
restores the default setting.
Sets the maximum
introduction; the "no default redistribute limit"
command restores the default setting.
Explanation
Introduces BGP routes, direct routes, static
routes and RIP routes as external routing
information; the "no redistribute ospfase
{ bgp | connected | static | rip }" command
cancels the introduction of external routing
information.
409
for external routes