Pim-Dm Configuration; Pim-Dm Configuration Task Sequence; Pim-Dm Configuration Commands; Ip Pim Dense-Mode - Accton Technology ES4710BD User Manual

If a pruned downstream node needs to restore to the forwarding state, the node will send a graft
packet to ask the upstream to restore multicast data forwarding.

19.3.2 PIM-DM Configuration

19.3.2.1 PIM-DM Configuration Task Sequence

1. Enable PIM-DM
Basic configuration of PIM-DM routing protocol on ES4710BD series switches is quite simple: just
enable PIM-DM in the appropriate interfaces.
Command
Interface Mode

ip pim dense-mode

no ip pim dense-mode
2. Configure PIM-DM sub-parameters
(1) Configure PIM-DM interface parameters
a. Configure PIM-DM HELLO packet interval
Command
Interface Mode
ip pim query-interval <query
interval>
no ip pim query-interval
3. Disable PIM-DM protocol
Command
Interface Mode
no ip pim dense-mode

19.3.2.2 PIM-DM Configuration Commands

ip pim dense-mode
ip pim query-interval
show ip pim interface
show ip pim mroute dm
show ip pim neighbor
debug ip pim
19.3.2.3 ip pim dense-mode
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Explanation
Enables PIM-DM protocol; the "no ip pim
dense-mode"
protocol (required)
Explanation
Sets the interval for sending PIM-DM HELLO
packets in the interface; the "no ip pim
query-interval" command restores the default
setting.
Explanation
Disables PIM-DM protocol
462
command disables PIM-DM