Accton Technology ES4710BD User Manual page 443

cost
State
Type
Priority
Transit Delay
DR
BDR
Authentication key
Timer：
Hello, Poll, Dead, Retrans
Number of Neigbors
Nubmer of Adjacencies
Adjacencies
（7）show ip ospf neighbor
The "show ip ospf neighbor" command can be used to display information about the neighbor OSPF
layer 3 switches.
For example, displayed information can be:
Switch#show ip ospf neighbor
interface ip 12.1.1.1
router id 12.1.1.2
state NFULL priority 1
DR 12.1.1.2 BDR 12.1.1.1
last hello 66261
interface ip 30.1.1.1
interface ip 50.1.1.1
router id 50.1.1.2
state NFULL priority 0
DR 50.1.1.1 BDR 0.0.0.0
last hello 66286
interface ip 51.1.1.1
interface ip 52.1.1.1
interface ip 100.1.1.1
interface ip 110.1.1.1
interface ip 150.1.1.1
router id 12.2.0.0
state NFULL priority 0
DR 150.1.1.1 BDR 0.0.0.0
last hello 66289
Displayed information
interface ip
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
area id 0
router ip addr 12.1.1.2
last exch 65712
area id 0
area id 0
router ip addr 50.1.1.2
last exch 49614
area id 0
area id 0
area id 0
area id 0
area id 0
router ip addr 150.1.1.2
last exch 49607
Cost value
Status
Layer 3 switch type, such as designated
Configure the priority in electing designated layer
3 switch.
The delay value for interface to transfer LAS
The designated layer 3 switch
Backup designated layer 3 switch
OSPF packet authentication key
OSPF protocol timer: including time set for
HELLO packet, poll interval packet, route
invalid, route retransmission, etc.
The number of neighboring layer 3 switches
The number of neighboring route interfaces
Neighboring interface IP address
Explanation
The IP address of an interface in the current
layer 3 switch
442